Table of Contents
Advertisement
I
CANOPY
iNSTALLATiON
FOR ALL TRACTORS
1
STEP 1" (Figure 20)
Assemble the upright tubes to the base assembly.
NOTE: If holes are difficult to align, loosen bolts attaching
base leg tubes to mounting bracket(s). If hole alignment
is still difficult, loosen bolts attaching mounting bracket to
rear fender. Retighten all bolts when finished.
j .....................
UPRIGHT
TUBES
5/16" x 2"
CARRIAGE BOLT
/
5/16" FLAT
WASHER
FIGURE 20
STEP 2:
(Figure 21)
Assemble the top tubes to the upright tubes. Do not
tighten yet.
STEP 3:
(Figure 21)
Fit the front U-tube onto the top tubes. Fasten the tubes
together. Tighten all loose bolts and nuts.
STEP 4:
(Figure 21)
Fit the three support rods into the holes in the top tubes,
with the rods arching upward. Do not over-bend the rods
when installing.
1/4" x 1-1/2"
HEX BOLT
U=TUBE
1/4" NYLOCK
NUT
/
1/4" × 1-1/2"
HEX BOLT
SUPPORT ROD
TOPTUBES
1/4"
NUT
FIGURE 21
STEP 5:
(Figure
22)
Place the vinyl canopy on top of the tubing frame, fitting
the front of the vinyl canopy around the front U-tube.
Secure the nylon mesh to the upright tubes using the ties
located on the corners of the mesh.
CAUTION:
Make sure tractor seat raises
and lowers freely after attaching Sun
Shade. The tractor's operator presence
safety switch will not operate if seat is
stuck down.
FIGURE 22
13
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
Table of Contents
