Craftsman 152.211620 Owner's Manual page 8

16
17
18
4
14
12
11
1, INNER WHEEL GUARD - Covers the grinding
wheeUs and protects against accidentaU contact,
2, WHEEL DRESSER - Used to clean and smooth
front surface of the grinding wheeUs,
3, FLEXIBLE WORK LIGHT - Provides Hght to the
operator during set up or grinding operations,
4, SPARK ARRESTOR - Prevents hot sparks and
debris from contacting the operator,
5, QUICK RELEASE KNOB - Remove knob to allow
the Quick Change WheeU Cover to be removed,
6, QUICK CHANGE WHEEL COVER - Covers the
grinding wheeUs and provides quick access for
routine maintenance,
7, GRINDING WHEEL 60 GRIT - Used to remove Hght
materiaU from workpbce,
8, TOOL RESTS - Used to support the workpbce
that is being ground, Adjustabb to provide angbd
surfaces,
9, DRILL BIT SHARPENING PLATE - Used to sharpen
twist drill bits, Should be removed for regular grind-
ing operations,
10, ON/OFF SWITCH - Used to turn ON and turn OFF
the grinder,
10
11, VARIABLE SPEED SWITCH - Permits adjusting
rotational speed of the grinding wheel,
12, QUENCH TRAY - Used to cool workpiece after
grinding,
13, TOOL REST ADJUSTABLE SUPPORTS - Lets the
operator position the tool rest closer to the wheel as
the wheel decreases in diameter due to wear,
14, 8" WIRE WHEEL - Used to remove rust and dirt
from workpiece,
15, EYESHIELD - Protective Lexan see-thru shields to
prevent any loose debris from contacting the
operator,
16, GRINDING WHEEL IDENTIFICATION LABEL -
Provides information on wheel size, grit and maxi-
mum rpm, Must be left on to distribute the load of
tightening the lock nuts,
17, FLANGES ° used to secure the grinding wheels to
the grinder and distribute the load of the Lock Nuts,
18, ARBOR HEX NUT - Used to secure the grinding
wheels to the grinder,
19, SPACER (not shown) - Used to align the wire wheel
or buffing wheel into the center of the tool rest,