Advertisement
,
,
Lubricate the Handlebar Shaft (54). Slide the Right Handlebar
(36) onto the right end of the Handlebar Shaft. (Note: Refer to
the drawing on the front cover and make sure that the Right
Handlebar is turned correctly.) Slide the Left Handlebar (37)
onto the left end of the Handlebar Shaft. Tap a 5/8" Push Nut
(35) onto each end of the Handlebar Shaft.
Slide an M8 Washer (5), a Link Arm Bushing (47) and a Link
Arm (26) onto the threaded pin on the lower end of the Left
Handlebar (37). Make sure that the Link Arm Bushing is
turned so the flange is next to the Washer. In addition, make
sure that the opening in the end of the Link Arm is down-
ward, as shown. Tighten an M8 Locknut (32) with an M8
Washer (5) onto the threaded pin.
Attach the other Link Arm to the Right Handlebar (not shown) in
the same manner.
47
,
For your convenience, the pedal assemblies have been pre-assembled.
Remove the 1/2" Locknut (23) from
one of the Pedal Shafts (16). Slide the 17.5mm Washer (56) onto the shoulder of the Pedal Shaft and firmly
tighten the Pedal Shaft clockwise into the right arm of the Crank (18). Next, tighten the 1/2" Locknut (23)
back onto the Pedal Shaft. Make sure that the 17.5mm Washer (56) can be moved back and forth on the
shoulder of the Pedal Shaft. Fit the end of the right Link Arm (26) onto the Pedal Shaft and slide the Link
Arm onto the Pedal Bushing
(25).
Attach the other pedal assembly to the left arm of the Crank (not shown) in the same manner.
Shoulder
/\,
\\
\
56
23
,,
.......................
\?
:
)
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: Some small
hardware may be left over after the exercise cycle is assembled.
6
Advertisement
