3. Make sure the memory card light (next to the card slots) is off and all the slots
are empty. Then insert your card as shown:
CompactFlash or
Microdrive (bottom)
The memory card light flashes, then turns green.
Note:
If the card is not properly formatted, you see a message on the RX620 screen.
Press the button indicated on the RX620 screen to format the card. Any data
stored on the card will be erased.
Scanning a Photo
After inserting a memory card, follow these steps to scan a photo to the card and
save it in JPEG format:
1. Open the scanner lid.
2. Place your photo face-down on the glass
in the upper-left corner, as shown.
Tip:
Slide your photo about 1/8 inch away from
the edges of the glass to ensure that the
edges of your photo are copied.
3. Close the scanner lid.
40
Scanning to a Memory Card
MemoryStick, SD, or
MMC (middle)
Memory
card light
SmartMedia or xD
(top)