Operation; Preparing For Operation; Switch - Craftsman 315.117151 Owner's Manual

OPERATION
Make sure power supply is 110-120 volts, 60 HZ, AC
only.
Before attempting to use your Sander, familiarize
yourself with all operating features (See Figure 1)
and _ requirements.
SWITCH
The switch of your sander is equipped with a "lock
on" feature which is convenient when sanding for
extended periods of time. TO lock-on, simply depress
the trigger of the switch, push in the lock button
located on the side of the handle, then while holding
the lock button pushed in, release the trigger. See
Figure 2. To release the lock, depress the trigger and
release it. If you have the "Lock-On" feature engaged
during use and your Sander becomes disconnected
from power supply, disengage the "Lock-On" feature
PREPARING FOR OPERATION
For ease of operation and maintaining proper con.
troL your Sander has a front handle and a rear han.
die. These handles allow two-hand operation which
aid in maintaining control, keeping sanding area
level with workpiece, and keeping hands clear of
sanding belt. When operating your Sander always
hold the front handle with your left hand anq the rear
handle with your right hand as shown in Fig. 2.
3.
KEEP HANDS AND FINGER: Fig. 3
AWAY FROM THESE AREAS AT ALL TIMES
DUST SAG TRACKING
SCREW
ANDING RELT_
FRONTIDLER PU
Fig 1
LOCK "ON" BUTTON REAR HANDLE
FRONT HANDLE
Fig
2
Always operate your Sander as shown in Fig. 2. Page S