Advertisement
SWITCH
LOCK
KEYLESS
CHUCK
See Figure 4.
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch
trigger, place the direction of rotation selector in
center position.
SELECTOR
REVERSE
CENTERPOSITION
(LOCK)
FORWARD
SWITCH
TRIGGER
Fig. 4
REVERSIBLE
See Figure 4.
This tool has the feature of being reversible. The
direction of rotation is controlled by a selector located
above the switch trigger. With the ddlt held in normal
operating position, the direction of rotation selector
should be positioned to the left of the switch for
drilling. The drilling direction is reversed when the
selector is to the fight of the switch. When the selector
is in center position, the switch trigger is locked.
To stop, release switch trigger and allow the chuck to
come to a complete stop.
See Figure 5.
Your new drill has a keyless chuck. As the name implies,
you can hand tighten or release drill bits in the chuck
jaws. Grasp and hold the collar of the chuck with one
hand. Rotate the chuck body with your other hand. The
arrows on the chuck indicate which directionto rotate
the chuck body in order to LOCK (tighten) or UNLOCK
(release) the drillbit.
UNLOCK
(RELEASE)
CHUCKBODY
DRILLBIT
LOCK
CHUCK
(TIGHTEN)
COLLAR
_
WARNING:
Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or your hand could slip and come in contact
with rotating drill bit. This could cause an
accident resulting in serious personal injury.
A
WARNING:
Battery tools are always in
operating condition. Therefore, switch should
always be locked when not in use or carrying at
your side.
9
Advertisement
