Download Print this page

Craftsman 315.111610 Owner's Manual page 5

3/8 in. two speed / reversible

Advertisement

RULES FOR SAFE OPERATION
(Continued)
An extensioncord should not be used unless
absolutely necessary.Use of improper
extension cord could result in a risk of fire and
electric shock. If extension cord mustbe used,
make sure:
a.
That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b.
That extension cord is properly wired and in
good electrical condition; and
c.
That wire size is large enough for AC
ampere rating of charger as specified
below:
Cord Length (Feet) 25'
50' 100' 150'
Cord Size(AWG)
16
16
16
14
Note: AWG = American Wire Gage
DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,
have replaced immediately by a qualified
serviceman.
Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take itto a qualified
serviceman.
Do not disassemble charger;take it to a
qualified serviceman when service or repair is
required. Incorrectreassembly may resultin a
risk of electric shock or fire.
To reduce risk of electric shock, unplugcharger
from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this risk.
Do not use charger outdoors.
Disconnectcharger from powersupply when
not in use.
SAVE THESE INSTRUCTIONS. Refer to them
frequentlyand use them to instruct others who
may use this tool. If you loan someone this tool,
loan them these instructionsalso.
_i,
Look for this symbol
to point out important
safety precautions.
It means attention!!!
Your
safety
is involved.
IMPORTANT
INFORMATION
FOR RECHARGING
HOT BATTERIES
When using your drill continuously,the battedes in your battery pack will become hot. You shouldlet a hot
battery pack cool down for approximately 30 minutes before attempting to recharge.
Note: This situation only occurs when continuous use of your drill causes the batteries to become hot. It does
not occur under normal circumstances. Refer to "CHARGING BATTERY PACK" for normal recharging of
batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery
pack and charger to your nearest Sears repair center for electrical check.
_I,
WARNING:
The operation of any power tool can result in foreignobjects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, available at Sears Retail Stores.

Advertisement

loading