Bissell 1697 POWERSTEAMER PRO SERIES User Manual page 7

The Basics - continued
Rotate Handle
to Unlatch
Fill Bladder only with
clean tap water.
Tank Drain Cap
8
4. Set the tank down and rotate the handle forward to
unlatch the lid. Lift off and set the lid aside.
5. Find the mouth of the bladder and fill to the bottom of the
neck with hot tap water.
NOTE: Fill the Bladder with water only.
6. Replace the tank lid matching the lid and tank edges.
Handle must be in forward position to reinstall.
7. Rotate the handle to the carrying position to re-latch
the lid.
8. Replace tank in machine base, seating firmly in place.
9. Rotate handle back down to the latched position.
When it's time to empty the Tank-in-Tank
10. Remove the Tank-in-Tank
on page 7.
11. Carry the Tank-in-Tank,
you will dispose of the dirty water.
12. Place in or at edge of sink, turn the Tank Drain Cap and
remove to release the dirty water.
13. Replace Drain Cap.
14. Refill with clean tap water as
above, steps 5 through 9,
and refill the SmartMix
with BISSELL cleaning solution,
as necessary.
15. If the cleaning job is complete, rinse out the Tank-in-Tank
by rinsing clean water between the bladder and tank.
16. Replace the Tank Drain Cap and return the Tank-in-Tank
to the machine, following steps 6 through 9 above.
17. Refer to the Putting it Away section, page 14, for the
final cleanup.
™ – follow steps 1 and 2
™ like a bucket, to the sink where
When filling bottle or
storing unit, set
dial to:
® Bottle
Latched
™
™
™