Download Print this page

Craftsman 172.10853 Owner's Manual page 23

7 1/4-in. circular saw
Hide thumbs

Advertisement

SERVICE
WARNING:
Preventive
maintenance
performed
by unauthorized
I
I
personnel
may result in misplacing
of internal
wires and components,
I
which
could cause a serious
hazard.
• All service that requires opening the saw MUST only be performed by a Sears
Service Center. All motor part represent
an important part of the double
insulation system and MUST only be serviced by a Sears Service Center.
Service performed by unqualified personnel could result in a risk of injury.
• When servicing this tool, ALWAYS use only identical replacement
parts.
Follow instructions in the Maintenance
Section of this manual. Use of
unauthorized parts or failure to follow Maintenance
Instructions may create a
risk of electrical shock or injury.
• Avoid solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged
by
their use. Use clean cloths to remove dirt, carbon dust, etc.
GENERAL
WARNING:
To avoid accidents,
ALWAYS
disconnect
the tool from
the power source BEFORE
cleaning or performing any maintenance.
All parts represent
an important part of the double
insulation system
and
should
be serviced
only at a Sears Service Center.
Avoid using solvents
when cleaning plastic parts.
Most plastics are
susceptible
to damage
from various types of commercial
Solvents
and may
be damaged
by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING: DO NOT
at any time let brake fluids, gasoline,
petroleum-based
products, penetrating
oils, etc. to come in contact
with
plastic
parts. They contain
chemicals
that can damage,
weaken
or destroy
plastic.
It is a known fact that electric
tools are subject
to accelerated
wear and
possible
premature
failure when they are used to work on fiber glass boats
and sports cars, wallboard,
spackling
compounds
or plaster. The chips and
grindings
from these materials
are highly abrasive
to electrical
tool parts,
such as bearings,
brushes,
commutators,
etc. Consequently,
it is not
recommended
that this tool be used for extended
work on any fiber glass
material,
wallboard,
spackling
compound,
or plaster. During any use on
these materials,
it is extremely
important
that the tool is cleaned
frequently
by blowing
with an air jet.
LUBRICATION
All of the bearings
in this tool are lubricated with a sufficient
amount of
high-grade
lubricant for the life of the tool under normal operating conditions.
Therefore, no further lubrication
is required.
/_ WARNING:
ALWAYS wear safety goggles
or safety glasses
with or
side shields when using this tool or blowing
dust. If operation is dusty, also
wear a dust mask.
23

Advertisement

loading

  Related Manuals for Craftsman 172.10853