See Figure 1.
Before attempting to use your sander, familiarize
yourself with all operating features and safety
If any parts are missing do not
operate your sander until the missing parts are
replaced. Failure to do so could result in possible
Your sander is suitable for sanding with coarse,
medium, and fine grit sandpaper. It will produce a fine
scratch free finish when used to sand with the grain
on wood surfaces. It has also been designed so that
sanding flush to corners is possible.
This tool is equipped with a slide switch located on the
rear handle of your sander. To turn sander ON, slide
the switch forward as shown in Figure 1. Slide the
switch back to turn your sander OFF. Be sure sander
switch is in OFF position before connecting to power
Your sander has a precision built electdc motor. It
should be connected to a power supply that Is 120
volts, 60 Hz, AC only (normal household current).
Do not operate this tool on direct current (DC). A
substantial voltage drop will cause a loss of power and
the motor will overheat. If your tool does not operate
when plugged into an outlet, double-check the power
Do not allow familiarity with your
sander to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
(Use only for the purposes listed below)
Sanding on wood surfaces.
Removing rust from and sanding steel surfaces.
Your sander should never be connected to power supply when you are assembling parts,
making adjustments, assembling or replacing sandpaper, cleaning, or when not in use. Disconnecting your
sander will prevent accidental starting that could cause serious personal injury.