Craftsman 315.175342 Operator's Manual page 10

Toinstallthe plungebase:
[] Unplug the router.
[] Place theplunge baseona fiatsurface.
[] Loosen thelockingknob.
[] Alignthegroove inthe motorhousing withtherib
inside the base.
NOTE: Therib is located onthe inside of thebasein
linewiththehandle.
[] Depress a ndholdthespindle lockbutton.
[] Slidethe motorhousing intothebase.
[] Tighten the lockingknob.
CAUTION:Donottighten the lockingknobwithout
the motorinstalled inthebase.Failure t o heed this
warning couldcause serious injury.
GROOVE
INMOTOR
HOUSING
RiBINSIDE
BASE
LOCKING
KNOB
SPINDLE LOCK
BUTTON
ARM
DEPTH ADJUSTMENT
RING
INDICATOR
ARROW
_i_ DEPTH
ADJUSTMENT
RING
INDICATORPOINT
Fig. 2
Fig. 3
SWITCHING FROM PLUNGE BASE TO FIXED
BASE
See Figures 4 - 6.
To remove the plunge base:
[] Unplug the router.
[] Place the router on a fiat surface.
[] Loosen the locking knob.
[] Depress and hold the spindle lock button. The spindle
lock button will not depress fully unless it is in line with
the hole in the collet.
[] If the spindle lock button does not depress fully, turn
the collet nut while depressing the spindle lock button.
When aligned, the spindle lock button will depress fully.
[] Remove the motor housing from the plunge base.
NOTE: When removing the motor from the base, the
spindle lock button must be depressed until it clears
the opening beneath the base.
10