Download Print this page

Clamping Wide Workpieces - Craftsman 172.24360 Owner's Manual

10-in. compound miter saw double insulated
Hide thumbs

Advertisement

Table of Contents
CLAMPING
WIDE WORKPIECES
(See Figure 31)
When cutting wide workpieces
(such as 2-in x 6-in. boards),
the boards should ALWAYS
be clamped with a hold-down
clamp or C-clamp as shown
in Figure 31.
GENERAL
I
I
Z_WARNING:
To avoid accidents, ALWAYS disconnect the tool from
the power source BEFORE cleaning or performing any maintenance.
/I'_WAHHIHLi:
Preventive
maintenance
performed
by unauthorized
personnel
may result in misplacing
of internal wires and components,
which could cause a serious hazard.
I
I
• All service that requires opening the saw MUST only be performed by a Sears
Service Center. All motor parts represent an important part of the double insulation
system and MUST only be serviced by a Sears Service Center. Service performed
by unqualified
personnel could result in a risk of injury.
• When servicing this tool, ALWAYS use only identical replacement
parts. Follow
instructions
in the Maintenance
Section of this manual. Use of unauthorized
parts
or failure to follow Maintenance
Instructions
may create a risk of electrical shock
or injury.
• Avoid solvents when cleaning plastic parts.
Most plastics are susceptible to damage
from various types of commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
I Z_WARNING:
DO NOT at any time let brake fluids, gasoline, petroleum-
I
I
based products, penetrating
oils, etc., to come in contact with plastic parts.
I
They contain chemicals that can damage, weaken or destroy plastic.
39

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Craftsman 172.24360