Craftsman 358.794311 Instruction Manual page 8

NOTE: Unit must be placed on its side
when adding fuel (see illustration below).
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
1, Move the throttle lever to the_
position.
2. Move the choke lever to the FULL
CHOKE position.
3. Slowly press the primer button 8
times.
Throttle Lever Primer Button
STOPPING YOUR ENGINE
• To stop the engine, move the throttle
lever to the STOP position.
STARTING THE ENGINE
_WARNING: You MUST make sure
the tubes are secure before using the
unit.
• Fuel engine. Move at least 10 feet (3
meters) away from the fueling site.
• Hold the unit in the starting position
as shown. Make sure the blower end
is directed away from people, ani-
mals, glass, and solid objects.
_STARTING POSITION
Blower
Vacuum
WARNING: When starting engine,
hold the unit as illustrated. Do not set
unit on any surface except a clean, hard
area when starting engine or while en-
gine is running. Debris such as gravel,
sand, dust, grass, etc. could be picked
up by the air intake and thrown out
through the discharge opening, damag-
ing the unit or property, or causing seri-
ous injury to bystanders or the operator.
Choke Lever
4. Pull starter handle sharply until the
engine attempts to run, but no
more than 5 pulls (below 30°F, 8
pulls).
NOTE: If the engine attempts to start
before the 5th pull, go to the next step
immediately.
5. Move choke lever to HALF CHOKE.
6. Pull the starter handle sharply until
the engine runs, but no more than
5 pulls (below 30°F, 10 pulls).
7. After a 5 second warm-up, move
the choke lever to the RUN posi-
tion.
8. Allow the unit to run for 30 more
seconds at RUN before moving the
throttle lever to the.!I- position.
If the engine has not started after 5
pulls (at HALF CHOKE), repeat the
STARTING A COLD ENGINE procedure.
If the engine still does not start, pro-
ceed to STARTING A FLOODED ENGINE.
9. To stop the engine, move the
throttle lever to the STOP position.
STARTING A WARM ENGINE
1. Move the throttle lever to the_
position.
2. Pull the starter handle sharply until
the engine starts, but no more than
5 pulls.
NOTE: If the engine has not started,
pull starter handle sharply for 5 more
pulls. If engine still does not run, it is
probably flooded. Proceed to START-
ING A FLOODED ENGINE.
3. To stop the engine, move the
throttle lever to the STOP position.
-8-