Electrical Assembly - Craftsman 917.242440 Owner's Manual

Electric lift actuator kit for garden tractors
Table of Contents

Advertisement

COMMON ELECTRICAL ASSEMBLY
Connect lift hamess to electricactuator.
a.
Connect male connector of harness to female
connector of electric actuator.
Viewing lift switch from under hood connect lift har-
ness to lift switch.
a.
Connect yellow wire of lift harness to lower right
terminal of lift switch.
b.
Connect double red wire of lift harness to lower
left terminal of lift switch.
c.
Connect single red wire to upper right terminal.
Secure wiring harness.
a.
Remove Iocknut (underside of tractor) on L.H.
saddle bolt.
b.
Install insulated clip over bolt as shown. Replace
Iocknut and tighten securely.
c.
Insert wiring harness in clip as shown.
Raise hood, insert female connector of lift harness
into male connector of tractor harness.
Ensure wire routing does not allow wires to rest on
sharp edges or near moving parts.
SHIFT
L.H. DASH
GATE
BOLT
COVER
WIRING
HARNESS
INSULATED
Fig. 23
BLACK
(GROUND)
WIRE
(TOP)
LOWER
LIFT
VIEWED FROM
BEHIND DASH
SINGLE
RED WIRE
FEMALE CONNECTOR
HARNESS)
MALE CONNECTOR
_RACTOR
HARNESS)
DASH
(CUTAWA_
O
VIEWED FROM
LEFT SIDE OF
TRACTOR
Fig. 24
DOUBLE
RED WlRE
Fig. 22
YELLOW
WIRE
REASSEMBLE TRACTOR
Reinstall rear wheel and mower deck, if removed
earlier.
Remove wood block.
Reconnect spark plug wire.
Retighten lift assist spring bolt.
16

Advertisement

Table of Contents
loading

Table of Contents