Electrical Assembly - Craftsman 917.242440 Owner's Manual

Electric lift actuator kit for garden tractors
Table of Contents

Advertisement

COMMON ELECTRICAL ASSEMBLY
WIRING ASSEMBLY FOR ALL
TRACTORS
(See Figs. 19 thru 24)
I_
BEFORE WORKING ON ELECTRICAL
SYSTEM DISCONNECT BATrERY. RE-
CONNECT BATrERY WHEN FINISHED.
Locate the black plastic plug in upper rightor left side
of dash. Remove plug and assemble lift switch.
NOTE: Plug location may be differentthan shown.
a.
Secure one nut to lift switchas shown.
b.
Enter lift switch in dash hole (with Keyway down)
from underside of dash, placing flat washer, inter-
nal tooth Iockwasher and nut over threaded area of
lift switch. Tighten nut securely.
Connect ground wire (black single wire) to lift switch.
a.
Viewing lift switch from under hood, connect black
wire to upper left hand side terminal of switch.
b.
Connect opposite end (eyelet) under the right or
left upper rear battery support nut. Support nut
(indicated by arrow) located on inside of right or left
side panel.
LIFT
SWITCH
BLACK
{GROUND)
WIRE
Fig. 20
RIGHT OR LEFT UPPER
REAR SUPPORT BOLT
RIGHT OR
PANEL
PLUG
Fig. 21
Fig. 19
15

Advertisement

Table of Contents
loading

Table of Contents