Wash Cycle Information; Operating The Dishwasher - Bosch SGE63E15UC/01 Operating Instructions Manual

Wash Cycle Information
The cycle times in this Use and Care Manual are based on normal soil loads and 120°F incoming water and will vary based on your actual conditions.
Table 3 - Wash Cycle Information
cycle time 110-135 min 105-129 min 80-85 min 95-119 min 30 min 70 min
cycle time with Half Load option 115 min 95-105 min 75-80 min 90-99 min not available 65 min
cycle time with Sanitation option 125-145 min 120-140 min not available 115-130 min not available not available
cycle time with Extra Wash option 145 min 120-140 min 95-105 min 115-135 min not available 85 min
water consumption 18.1-23.7 L 13.1-24.9 L 8.8-13.9 L 5.8-16.9 L 10.3 L 12.9 L
4.8-6.3 gal 3.5-6.6 gal 2.3-3.7 gal 1.5-4.5 gal 2.7 gal 3.4 gal
wash temperature 66-71°C 55-66°C 45-50°C 50-55°C 45°C 50°C
150-160°F 130-150°F 113-122°F 122-131°F 113°F 122°F
rinse temperature 72°C 70°C 63°C 51-69°C 50°C 60°C
162°F 158°F 145°F 124-156°F 122°F 140°F
Note: Only sanitizing cycles have been designed to meet the requirements of 6 for soil removal and sanitization efficacy. There is no
intention, either directly or indirectly, that all cycles have passed sanitization performance tests.
Operating the Dishwasher
NOTE: The SHE9ER55UC models have hidden controls, therefore, the door must be opened before chang-
ing settings and closed after changing settings.
Start the dishwasher
1 Press the [On/Off] button. The LED of the last selected cycle flashes.
2 Select a cycle and desired options.
3 Press [Start].
Cancel a cycle
1 Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
2 Wait about 1 minute while the dishwasher drains.
3 Open the door and press the [On/Off] button.
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the On/Off button again.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 4) and press [Start:] until the display indicates "H:00".
3 Release both buttons.
4 Press the "A" button until the display shows "r:05".
s Press the "C" button to select the desired setting.
"r:O0" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Press [Start] to save the setting.
6
13