Table of Contents
Advertisement
O
3.14
C
T
: TV O
HAPTER
HREE
P E R AT I O N
Viewing a VCR or Camcorder Tape
You must select the appropriate mode in order to view the VCR or
Camcorder signal on the TV.
1
Make sure that the remote control is controlling the TV set.
(Press the MODE button and make sure that the "TV" LED is
illuminated.)
2
Press TV/VIDEO on the remote control, and the following on-
screen menu will appear:
TV/Video Menu
ANT/CATV
Video1
Video2
Video3
S-Video1
S-Video2
DVD
PC
3
Use the CH
or CH
button to highlight a
particular signal source,
and then press VOL+ to
activate it.
Press TV/VIDEO to exit.
When you press the TV/Video button, the on-screen
display identifies all the active video sources (and their
corresponding input jacks):
Select
Video 1
Video 1 (rear panel)
Video 2
Video 2 (rear panel)
Video 3
Video 3 (front panel)
S-Video 1
S-Video 1(rear panel)
S-Video 2
S-Video 2 (front panel)
DVD
PC
PERATION
ANT 4
ANT/CATV
Video 1
Connected
Video 2
Connected
Video 3
Connected
S-Video 1 Not connected
S-Video 2 Not connected
DVD
Not connected
PC
Not connected
Move
Ent. TV/Video Exit
Video jack
Audio jack
Audio 1 "L+R"
Audio 2 "L+R"
Audio 3 "L+R"
Audio 2 "L+R"
Audio 3 "L+R"
DVD-rear
DVD Audio "L+R"
PC INPUT
PC Audio "L+R"
Advertisement
Table of Contents
