GE Profile WPDH8800 Owner's Manual & Installation Instructions page 16

Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature
should never be below 60°F (15.6°C)for proper
washer operation.
2. In an area where it will come in contact with curtains
or drapes.
3.On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
B0 cm). To make sure the washer does not vibrate
or move, Uou mau have to reinforce the flooE
NOTE: If floor is in poor condition, use B/4" impregnated
plywood sheet solidlu attached to existing floor covering.
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = O" (0 cm)
• When installed in closet: Sides, Rear,
Top = O" (0 cm), Front = 1" (2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (B87 cm2),located B"
(7.6 cm) from top and bottom of door
ROUGH-IN DIMENSIONS
FRONT
• _ 27.0" _"
(68.6 cm)
................. _ oo o @
J o o o oo_ .:
SIDE
32.1"
(81.5crn)
*NOTE:
With Washer Legs: 40.5" (102.5 cm/
(0.75" adjustability)
With Pedestal: 53.75" (136.6 cm)
(0.75" adjustabilit M)
Stacked: 82.75" (209.8 cm/
39.2"*
(99.5 cm)
39.2"*
{99.5 cm)
16