Craftsman 247.24019 Operator's Manual page 11

Assembling Remaining Bagger Components
Nowthat the mountingbracketsare assembledand are inplaceon
the tractor,followthese stepsto assemblethe remainingbagger
components.
1. Snapthe upper chutesupportin placeby firstclippingthe side
portionontothe bin support rail.Align theedge of the snap
featurewith the red line (1),as shownin the inset of Fig. 13.
2. Snapthe front portionof the upperchute supportto the bin
supportrail as seenin2 of Fig. 13.
f
\
Figure13
3. Installthegrass catchercover screenintothe baggercoverby
first inserting t he end closestto the sidewith thecutoutintothe
mountinghole,as in Fig. 14.Makesureto feed the screenunder
the lip,as in Fig. 15.
4. Clipin the otherside byflexing thescreenand pushingitdown
intothe providedcutouthole.See Fig. 15.
Figure14
Makesurescreensits
underthe cover's lip
Figure15
Installthe grass catchercoverontothe bin supportassembly,as
seenin Fig. 16.The grass catchercovergoes inside of the two
mountingtabs on the bin supportassembly.
Figure 16
Slidethe hingepin intothe hole locatedon the mountingtab, as in
Fig. 17on the followingpage. Use thecut-outwindow(See inset
inFig. 17)to line up the hinge pin on the otherside and pushpin
all the wayin until itreachesthe end-stop.At this pointthe pin
clips intoplaceand issecuredby a tab inthe baggercover.See
Fig. 18.
11