Setting Up For Use Over Wired Lan - Canon MX7600 - PIXMA Color Inkjet Network Setup Manual

2-1 Setting Up for Use over Wired LAN

Important
When the machine has not been connected to the network, to set up the machine to be used from a LAN-
connected computer, the necessary software must be installed on the computer. See "1 Preparing for
Setup" on page 17 and "2 Installing the Software" on page 18 to confirm that the software installation is
complete, then proceed with the procedure below.
1
On the Canon IJ Network Tool screen,
select LAN connection, then click OK.
If the Canon IJ Network Tool does not start up
automatically, select Library > Printers > Canon >
BJPrinter > Utilities > Canon IJ Network Tool.
Note
If you select USB connection, the Canon IJ Network
Tool will exit without setting up the machine to be used
over wired LAN.
If the screen shown on the right appears, make
sure of the following, then click OK.
– The machine is turned on.
– The machine is connected to the computer with a
USB cable.
– The MP Drivers have been installed.
2
Select Setup in the pop-up menu, select your
machine's name in Printers, then click OK.
Note
If no printer is detected, click OK. Make sure of the
following, then click Update.
– The machine is connected to the computer with a
USB cable.
– The machine is turned on.
If the machine's network settings are already
configured, the Setup Environment Confirmation
dialog box appears asking for your confirmation to
use the machine with the current settings. You can
proceed with the setup using the current network
settings. To do so, click Use as is. To reconfigure
the network settings, click Reconfigure.
Setting Up the Machine and the Computer (Macintosh)
(continued from step 12 on page 22)
23