Download Print this page

Yamaha Modus F02 Owner's Manual page 43

Owner's manual
Hide thumbs

Advertisement

3.
Fasten B, C and D securely.
Tighten the screws securely in the order shown in the
illustration. Be careful not to permit misaligned levels on
the front surface, or a gap on the top surface of B, C and
D.
4.
Attach part E.
Align the second and fourth holes on E with the bracket
holes on the bottom of A, then secure the bracket using
two short screws (6 × 14 mm).
5.
Connect the AC power cord.
Insert the AC power cord plug into the AC IN connector
on the rear of A.
For models that feature a voltage selector:
Set the voltage selector to an appropriate voltage.
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
"minus" screwdriver to rotate the selector dial so that the correct
voltage for your region appears next to the pointer on the panel.
The voltage selector is set at 240V when the unit is initially
shipped. After the proper voltage has been selected, connect the
AC power cord to the AC IN and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the pin
configuration of the AC wall outlets in your area.
Edges must be flush.
Do not allow a gap.
Voltage
selector
WARNING
An improper voltage setting can cause serious damage to the
instrument or result in improper operation.
After completing the assembly, please check the
following.
• Are there any parts left over?
→ Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other
movable fixtures?
→ Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when
you shake it?
→ Tighten all screws.
→ Be sure to install the fall-prevention brackets securely.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the
assembly diagrams and retighten all screws.
CAUTION
When you move the assembled instrument, be sure to grasp
the handles and the bottom of the keyboard. Do not hold the
key cover. Improper handling can result in damage to the
instrument or personal injury.
Key cover
Hold here.
CAUTION
If the main unit creaks or is otherwise unsteady when you
play on the keyboard, refer to the assembly diagrams and
retighten all screws.
Do not hold here.
Appendix
F02 Owner's Manual
43

Advertisement

loading

  Also See for Yamaha Modus F02