Turning the Power On
Connect the Power cord.
First insert the plug of the power cable into the AC
connector on the instrument, then plug the other
end of the cable into the proper AC outlet on the
wall. In some areas a plug adaptor may be provided
to match the pin configuration of the AC wall
outlets in your area. For more information on
connecting the power cord, refer to the assembly
instructions on page 43.
• Make sure your instrument is rated for the AC voltage
supplied in the area in which it is to be used (voltage rating
appears on the name plate on the bottom panel). In some
areas, a voltage selector may be provided on the rear panel
of the main keyboard unit near the AC IN. Make sure that
the voltage selector is set for the voltage in your area.
Connecting the unit to the wrong AC supply can cause
serious damage to the internal circuitry and may even pose
a shock hazard!
• Use only the AC power cord supplied with your instrument.
If the supplied cord is lost or damaged and needs to be
replaced, contact your Yamaha dealer. The use of an
inappropriate replacement can pose a fire and shock
• The type of AC power cord provided with your instrument
may be different depending on the country in which it is
purchased. (In some areas a plug adaptor may be provided
to match the pin configuration of the AC wall outlets in your
area.) Do NOT modify the plug provided with your
instrument. If the plug will not fit the outlet, have a proper
outlet installed by a qualified electrician.
The shape of the plug and outlet
differ depending on locale.
Turn the power on.
Press the [ ] Power switch located on the right of
the keyboard to turn the power on.
The Power indicator located below the left end of
the keyboard lights up.
If you close the key cover without turning the power
off, the Power indicator remains lit, indicating that
the power is still on.
When you're ready to turn off the power, press the Power
The Power indicator turns off.
Even when the instrument is turned off, electricity is still
flowing to the instrument at the minimum level. When you
are not using the instrument for a long time or during
electrical storms, make sure you unplug the AC power plug
from the wall AC outlet.
Connect a pair of headphones (option) to one of the
[PHONES] jacks. Two [PHONES] jacks are provided. You
can connect two sets of standard stereo headphones. If
you are using only one pair of headphones, you can plug
them into either of these jacks.
Do not use headphones at a high volume for an extended
period of time. Doing so may cause hearing loss.
F02 Owner's Manual