Panasonic SC-BT300 Operating Instructions Manual page 34

Network settings
Setting the connection speed
When the connection test results in "Fail" after the IP and DNS-IP
addresses are assigned, perform the following settings.
After performing steps O to O (_ 33)
O Press [A, V] to select "Auto Detect
Connection Speed" and press [_, I_] to select
"Off".
O Press [A, V] to select "Connection Speed
Setting"
and press
[_, I_]
to select a
connection
speed.
• Select a connection speed in accordance with the environment of
the network connected.
• When the settings are changed, the network connection may be
disabled depending on the device.
Testing of .Proxy Server Settings,,
Always test the connection when new "Proxy Server Settings" have
been made.
O Press [BD/SD] to select "BD/DVD" or "SD".
Press [SETUP].
_t Press [A, V] to select "Network" and press
[OK].
O Press [A, V] to select "Proxy Server Settings"
and press [OK].
Q Press [A, V] to select "Connection Test" and
press [OK].
Setting the proxy server
In most cases, default settings can normally be used without
making any changes.
Please use this setting when instructed to by your Internet
service provider.
After performing steps O to O (_> left)
Q Press [A, V] to select "Proxy Address" and
press [OK],
• The text entry screen is displayed.
Text field: shows the text you have entered
[]_ []D%DDm[]DD[]@
@E_]%DD%%%%B3E3
Press [A, V, _, I_] to select a character and
press [OK].
Repeat this step to enter other characters.
• Press [I IPAUSE] to delete.
Press [==STOP] when you complete the entry.
Q Press [A, V] to select "Proxy Port Number"
and press [OK].
(_) Enter numbers with the numbered buttons and
press [OK].
"Testing...":The test is in progress.
"Pass": The connection is completed.
Press [RETURN] to exit.
"Fail": Please check the connection and settings.
(_) Press [_1, I_] to select "Yes" and press [OK].
©
TIPS
=The specified ports may be bocked and not be able to be
used depending on the network environment.
In order to restore the default settings
After performing steps O to O (_ left)
1 ) Press [A, V] to select "Reset to factory preset" and
press [OK].
2) Press [_1, I_] to select "Yes" and press [OK].
Using the numbered buttons to enter characters
e.g., entering the letter "F
__ 4
N[[il L- I - -
1 ) Press 13] to move to the 3rd row.
2) Press [3] twice to highlight "F".
3) Press [OK].
RQT9371