Table of Contents
Advertisement
Network settings
These settings are used if you will connect this unit to the Internet.
oThe connection to the Internet may take time or the Internet may not be connected depending on the connection environment.
(_ 40)
It is required that you use a broadband connection.
Preparation
oConnect to a broadband network. (_ 14)
Always test the connection when a LAN cable is connected.
O
Press [BD/SD] to select "BD/DVD"
or "SD".
l_
Press [SETUP].
_)
Press
[A,
I']
to select
"Network"
and
press
[OK].
O
Press [A, I'] to select "IP Address/DNS
Settings"
and
press
[OK].
Q
Press
[A,
I']
to select
"Connection
Test"
and
press
[OK].
IPAddressAuto
Con_guration
( DHCP
)
l
]
DNS Auto Configuration
( DHCP
)
Auto
Detect
Connection
Speed
I
]
Connection
Speed
Setting
I
Setting the IP address
In most cases, default settings can normally be used without
making any changes.
Set the IP address only when the router has no DHCP server
functions
or when the router's DHCP server function
is
disabled.
After performing
steps O to O (_ left)
Q
Press [A, T] to select "IP Address
Auto
Configuration
( DHCP )" and press [4,
I_] to
select "Off",
Q
Press [A, T] to select "IP Address",
"Subnet
Mask" or "Default
Gateway" and press [OK],
O
Enter numbers
with the numbered
buttons
and
press [OK],
oAfter checking the specifications
for your broadband router,
enter each number.
If the number is unknown, then check the number of other
devices such as personal computers connected via a LAN
cable. Assign a different number from those of other devices
for the "IP Address" and the same number for others.
• If a wrong number is entered, then press [CANCEL].
Q
Press [<, I_] to select "Yes" and press [OK],
• Th e numedc iBPU! iange ii between 0 and 255.
"Testing...":The
test is in progress.
"Pass":
The connection is completed.
Press [RETURN] to exit.
"Fail":
Please check the connection and settings.
• Perform the !'Connecti0n Test" also When any change was
made to !he i_! P Add[ess!DNS
Se!tings!i!
NOTE
• If the connection test fails, it may be necessary to set the MAC
address of this unit at the router side. The MAC address can be
displayed by pressing [SETUP] and selecting "Network".
{
IP Add ress/DNS Settings
i
i;,
Proxy Server Settings
{
{ { { { { { { { { { {
;_{ { { { { { { { { { { { { { { { { { { { {
Network Service
In most cases, default settings can normally be used without
making any changes.
When setting an assigned
DNS server from your Internet
service provider, perform the following
settings.
After performing
steps O to O (_> left)
Q
Press [A, T] to select "DNS Auto
Configuration ( DHCP )" and press [4,
I_] to
select "Off",
Q
Press [A, T] to select "Primary
DNS" or
"Secondary
DNS"and press [OK],
Enter numbers
with the numbered
buttons
and
press [OK],
• Follow the instructions
given by your Internet service provider
and enter the numbers.
If the number is unknown, then check the number of other
devices such as personal computers connected via a LAN
cable and assign the same number.
• If a wrong number is entered, then press [CANCEL].
Q
Press [<1, I_] to select "Yes" and press [OK].
;:_
,The numeric input range is between 0and
255_
NOTE
RQT9371
Hide quick links:
Advertisement
Table of Contents
