Electrolux EKD60760 User Manual page 26

26 electrolux
Cleaning the oven
Warning! When cleaning, no oven
functions must be selected and the oven
must have cooled down.
In order to facilitate cleaning, the side rails
should be removed.
Catalytic enamel
The catalytic enamel on the oven walls and
top is porous and has a certain self-cleaning
effect. The oven bottom, on the other hand
is made of a smooth and rather harder en-
amel from which you can scrape off spilled
material with a spatula or something similar.
Warning! The oven gets hot during use.
Keep an eye on children.
Dirt on the enamel is partly burnt off when the
oven is used. If there are flecks on the en-
amel, burn off the oven at the highest tem-
perature with top/bottom heating for 30–60
minutes. Remove stubborn marks, for exam-
ple fat, like this:
1. "Drench" the catalysis enamel with soft
soap and hot water. Use a nylon brush on
the flecks. Leave it alone for one hour.
2. Then turn on
the highest temperature.
3. Switch off the oven after three hours.
Warning! Do not use oven spray or
abrasive cleaning agents. Never use
oven cleaning compound or sharp
objects on the catalysis enamel. The
catalytic sheeting may otherwise be
damaged.
The smooth enamel
The following should be done if the oven bot-
tom is very dirty:
1. Spillages that have become stuck can be
loosened with a spatula or something
similar.
2. Spread soft soap on the bottom of the
oven with a sponge.
3. Close the door. Set the oven at 100°C
with conventional heating
minutes.
4. When the oven has cooled down, rinse it
with clean water or, if necessary, rub
carefully with a soap pad. Wipe dry.
The oven door
The oven door can be removed for cleaning.
conventional heating and
for about 10
When the oven door opens, the lamps
light and the hot air fan stops.
Removing the door:
1. Open the oven door about one-third of
the way (parking position).
2. Grasp the sides of the oven door with
both hands and pull the door off the oven.
3. Lift off the door
Fitting the door:
1. Make sure that the hinge unit is in its
parking position.
2. Insert the hinge unit in the slot on the
door. Press down until the assembly
spring clicks into position.