Table of Contents
Advertisement
16 electrolux
Meat
INTERNAL TEMPERATURES –
°
Rare: 50 - 60
C; Medium: 60 - 70
The roasting temperatures and times given in the chart should be adequate for most joints, but slight
adjustments may be required to allow for personal requirements and the shape and texture of the
meat. However, lower temperatures and longer cooking times are recommended for less tender cuts
or larger joints.
Wrap joints in foil if preferred, for extra browning uncover for the last 20 - 30 min. cooking time.
If you cover the food with foil or lid allow an extra 10-15 minutes for each ½kg (1lb)
Care and cleaning
Warning! Before cleaning always allow
the appliance to cool down before
switching off at the electricity supply.
Cleaning materials
Before using any cleaning materials on your
appliance, check that they are suitable and
that their use is recommended by the man-
ufacturer.
Cleaners that contain bleach should NOT be
used as they may dull the surface finishes.
Harsh abrasives and scourers should also be
avoided.
Multi-surface antibacterial cleaning products
should not be used on the ceramic hob or on
the surrounding trims.
Cleaning the outside of the appliance
Do not use abrasive cleaning materials or
scourers on painted or printed finishes as
damage may occur.
Regularly wipe over the control panel, doors
and appliance sides using a soft cloth and
hot soapy water.
To prevent streaking finish with a soft cloth.
Stainless Steel cream cleaners are abrasive
and should be avoided as they may dull the
surface finish.
Any spillage on the stainless steel finish must
be wiped off immediately.
Warning! Do not attempt to remove any
of the control knobs from the appliance
as this may cause damage and is a
safety hazard.
Cleaning the control knobs and handles
It is strongly recommended that only hot
soapy water is used for cleaning the control
knobs and handles.
ANY OTHER CLEANING MATERIALS MAY
DULL THE SURFACE FINISH.
Gas Mark
°
C; Well done: 70 - 80
Removing and replacing the wire work
runners
1. Remove all shelves
2. Hold the wire work at
3. Unhook the runner
4. To replace the run-
Cleaning the gas hob
Clean the hotplate top using a mild abrasive.
Take care not to damage the spark electro-
des. If the spark electrodes are damaged the
burners will not light.
You can remove the pan supports, burner
caps and burner crowns to clean them.
Again take care not to damage the spark
electrodes.
Clean the burner crowns and pan supports
by soaking them in very hot soapy water.
Aluminium based saucepans can leave shiny
metal marks on the pan supports.
You can remove any stubborn stains by
scouring with a soap impregnated steel wool
pad.
Cooking time
°
C
and furniture from
the oven.
the bottom, unclip
from the cavity side
and gently pull to-
wards the centre of
the oven.
at the top and re-
move from the cavi-
ty.
ners, hook the wire
work side runner into
the cavity, slide back
and press into place.
Warning! Ensure
the wirework runners are firmly in
position before replacing the oven
shelves.
Advertisement
Table of Contents
