Download  Print this page

Electrolux EDC47130W User Manual page 17

Sensor dry 7kg condenser dryer
Hide thumbs

Advertisement

Once in its permanent operating position, check
that the dryer is absolutely level with the aid of
a spirit level. If it is not, raise or lower the feet
until it is.
The feet must never be removed. Do not restrict
the floor clearance through deep pile carpets,
strips of wood or similar. This might cause
heat build-up which would interfere with the
operation of the appliance.
Important
The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The appliance
must therefore not be installed on floors which
are not resistant to high temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Stacking kit
A special stacking kit is available through your
dealer, to enable the mounting of the dyer on
top of a front loading washing machine which
cover's a depth between 48 and 60cm.
Read carefully the instructions supplied with the kit.
Electrical connection
This machine is designed to operate on a
230-240V, single-phase, 50Hz supply. Check
that your domestic electrical installation can
take the maximum load required, also taking
into account any other appliances in use.
Connect the machine to an earthed socket,
in accordance with current wiring regulations.
The manufacturer declines any responsibility
for damage or injury through failure to
comply with the above safety precaution.
Should the appliance power supply cable
need to be replaced, this must be carried
out by our Service Centre.
Important!
The power supply cable must be
accessible after installing the machine.
electrolux installation 17

Hide quick links:

Advertisement

loading

  Also See for Electrolux EDC47130W