Operation - Dimplex DFB8842 Owner's Manual

Operation

Electric Fireplace Manual
Controls
The manual controls for the
fireplace are located in the lower
right hand corner (Figure 3).
A. Main On/Off Switch
Supplies power to the 3
position manual control switch.
B. 3 Position Manual Control
Switch
Remote (right position):
The unit is operated with the
remote control.
Flame (center position): The
flame effect is turned on.
Flame & Heat (left position):
The flame effect and heater
are turned on simultaneously.
When the manual control is
in the Flame & Heat position
the heater does not run on the
remote operated thermostat.
C. Initialization Button
used to synchronize remote
control.
!
NOTE: When the manual
control switch is in the Flame
and Flame & Heat positions,
the fireplace unit will not
operate with the remote
control.
10
Figure 3
A
Resetting The
Temperature Cutoff
Switch
The heater is protected with
a safety device to prevent
overheating. should the heater
overheat, an automatic cut out
will turn the heater off and it will
not come back on without being
reset. It can be reset by switching
the on/oFF switch to oFF and
waiting five (5) minutes before
switching the unit back on.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call
Dimplex north America Limited
at 1-888-346-7539. Have
the product model and serial
numbers ready when calling.
C
B
www.dimplex.com