Figure 57 Liebert Xdc Piping Locations; Table 25 Liebert Xd Chiller Piping Connection Sizes - Emerson Liebert Xtreme Density Design Manual

Figure 57 Liebert XDC piping locations

* Allow 8" (204mm) of clearance for filter replacement
** To ensure all refrigerant flow is filtered, install the filter dryer assembly
between the discharge line of the XDC and the first bypass flow controller
or the first cooling module.
Table 25 Liebert XD Chiller piping connection sizes
Air Cooled Models
50/60Hz
Liebert XDC160
Liebert XD Cooling Modules—Liebert XDO, Liebert XDV, Liebert XDH and Liebert XDCF
** To first cooling module
or bypass flow controller
F - Return From Cooling Units
47"
(1193.8mm) 44"
(1117.6mm)
6" (152mm)
23"
(584.2mm)
Dimensions are
approximate and
subject to change
without notice.
A - Hot Gas
Refrigerant Lines
Piping Outlet Connection Sizes, OD Cu, inches
A B
1-3/8 7/8
Install replaceable filter dryer
assembly in liquid supply line G
B - Liquid
Refrigerant Lines
C D
- -
56
* Orientation determined
by installer.
G - Supply to Cooling Units
DPN000768
Page 3, Rev. 6
E F
- 2-1/8
G
1-1/8