Ip Concepts - D-Link DSL-G604T User Manual

DSL-G604T 54Mbps Wireless ADSL2/2+ Modem/Router Manual
C

IP Concepts

This appendix describes some basic IP concepts, the TCP/IP addressing scheme and show how to
assign IP Addresses.
When setting up the Router, you must make sure it has a valid IP address. Even if you will not use the
WAN port (ADSL port), you should, at the very least, make sure the Ethernet LAN port is assigned a
valid IP address. This is required for telnet, in-band SNMP management, and related functions such as
"trap" handling and TFTP firmware download.
IP Addresses
The Internet Protocol (IP) was designed for routing data between network sites all over the world, and
was later adapted for routing data between networks within any site (often referred to as "sub
networks" or "subnets"). IP includes a system by which a unique number can be assigned to each of
the millions of networks and each of the computers on those networks. Such a number is called an IP
address.
To make IP addresses easy to understand, the originators of IP adopted a system of representation
called "dotted decimal" or "dotted quad" notation. Below are examples of IP addresses written in this
format:
201.202.203.204 189.21.241.56 125.87.0.1
Each of the four values in an IP address is the ordinary decimal (base 10) representation of a value that
a computer can handle using eight "bits" (binary digits — 1s and 0s). The dots are simply convenient
visual separators.
Zeros are often used as placeholders in dotted decimal notation; 189.21.241.56 can therefore also
appear as 189.021.241.056.
IP networks are divided into three classes on the basis of size. A full IP address contains a network
portion and a "host" (device) portion. The network and host portions of the address are different
lengths for different classes of networks, as shown in the table below.
84