X-10 POWERHOUSE PS561 Owner's Manual page 31

If you do not want this to happen, set
the Appliance Module(s) to a different
Housecode from the one you set on
the Console.
If you do not hear a beep from the
Console when you press [ARM] to
install a Remote Control:
Check to see if you can arm the sys-
tem when the Console is in the RUN
mode. If you can, the Remote Control
is already installed and no further ac-
tion is necessary. If not:
1. Check that the Console is set to the
INSTALL mode.
2. Press [CODE] on the Remote Con-
trol with a pencil, then press
[ARM] again.
If you do not hear a beep from the
Console when you press [TEST] to
install a Door/Window Sensor or
Motion Detector:
With the Console in the RUN mode,
check that it chimes when you press
[TEST] on the sensor/motion detector.
If it does, the sensor/motion detector is
already installed and no further action
is necessary. If not:
1. Check that the Console is set to the
INSTALL mode.
2. Press [CODE] on the sensor/motion
detector with a pencil, then press
[TEST] again.
Note: Doing this when the sensor/
motion detector is already installed,
installs it AGAIN into the next zone.
If the battery indicator on the Con-
sole is on.
Replace Console's battery. A 9V alka-
line battery provides approximately 12
hours of back-up. Replace battery at
least once a year.
If a zone indicator is off when a
door/window is open or on when a
door/window is closed.
Check position of N.0/N.C. switch
inside sensor's battery compartment. It
should be set to N.C. for type of
switches
supplied.
There is a slight chance that your sys-
tem might have received a signal from
a neighbor's system. Remove the bat-
tery from the sensor for that zone for
at least 4 hours. Then re-install the
sensor. To do this, press CODE with
the point of a pencil, then press TEST.
If you lose your Remote Control:
Re-install your complete system to
prevent someone else from using the
lost Remote Control.
If the system arms or disarms by it-
self:
A neighbor may have a compatible
system. Re-install the complete system
so that it chooses different RF codes.
If red light on remote control stays
on during installation:
Press [CODE] then press [ARM]. If it
still stays on, remove the battery, wait
a few seconds, then replace the bat-
tery. Press [CODE] then press [ARM]
again.
31