Siemens Multi Address Appearance (MAA) On OpenStage Technical Paper page 11

On openstage phone
Table of Contents

Advertisement

The phone can be configured by the administrator to select automatically the outgoing line, if the user
initiates an outgoing call.
1.
Idle line
The phone will use the next available idle line. Lines are configured with a priority order. The
phone will use the order to use the next free line.
2.
Primary
The phone will use the primary line to set up the outgoing call. If the primary line is blocked,
the phone will show a reminder popup, that no outgoing line is available.
3.
last
The phone will use the last line, which was taken for the previous in- or outgoing call. If the
last line is already in use, the phone will show a reminder popup, that no outgoing line is
available.
4.
none
This setting is used to enable manual seizure. The user is asked to select the outgoing line.
Dialing the last dialed number
The last dialed number is displayed in the outgoing call popup. The number shown in this popup is
always the last dialed number of the private line. Calls done with secondary line are not recorded in call
log and not presented as last dialed number.
Call Forwarding
The call forwarding can only be activated for the primary line. If a call forward for secondary lines
should be performed a central switch feature accessed via stimulus feature key must be set.
Putting a line on hold
An existing Call can be put on hold. Additional to the standard mechanism the line key can be used to
put the call for this line on hold, if the Administrator has set the 'Line action mode ' setting
accordingly. A flashing LED is indicating the held call. If the line key is pressed again a held call will be
retrieved.
Remark: The call status per line can also be seen on the line overview screen
Warning: In difference to a single user phone the held call is not shown in the phone screen. This
might confuse the user knowing the behaviour of a single user phone.
Within a MAA scenario a held call releases the phone audio resources again and it can be used to make
calls from other lines. Therefore the phone switches back to idle screen, if the existing call is put on
hold by the user. The flashing line led and the line overview are the only indications that call is on hold.
The phone will not remember the user that a call is still on hold after some time. This feature is for
single user phones only.
Resource Handling
The phone has local resources for two concurrent calls. If the resources are exhausted no further call
can be set up and the phone will deny any further requests. Here is an example for a three way
conference.
Multi Address Appearance on OpenStage
00.00.2007 I 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multi address appearanceMaa

Table of Contents