Reset To Defaults - Asus WL-300G User Manual

Problem
The ASUS AP Device Discovery still cannot find or connect to
the ASUS AP after verifying the IP address and LAN cable,
changes cannot be made, or password is lost.
Solution
In case the ASUS AP is inaccessible, you can restore the
ASUS AP's factory default settings. Use a straightened paper
clip to press the button located in the hole on the back of the
ASUS AP and keep it depressed over 5 seconds. The power
LED will darken and then light up when reset is successful.

Reset to Defaults

The following are factory default values. These values will be present when you
first receive your the ASUS AP , if you push the reset button on the back of the
ASUS AP over 5 seconds, or if you restore factory settings through the ASUS
AP software.
Name
Wireless - Interface
SSID
Channel
Encryption (WEP)
Broadcast SSID
Wireless - Bridge
AP Mode
Wireless - Access Control
MAC Access Mode
IP Config - LAN
IP Address
Get IP Address Automatically
Subnet Mask
Gateway
System Setup - Password
Operation Mode
User Name
Password
Chapter 4 -Troubleshooting
Default Value
default
6
None
No
Access Point Only
Disabled
192.168.1.1
Yes
255.255.255.0
(blank)
Access Point
admin
admin
ASUS 802.11g Access Point 49