I Hookups; Dvd/Vcr To Tv Connection; Rf Output Channel; Connecting To A Tv - Emerson EWD2003 Owner's Manual

CAUTION:
¡ Be sure to turn off the DVD/VCR COMBINATION UNITS and equipment to be connected before connecting.
¡
Read through the operation manual for the equipment to be connected.
¡
Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.
¡
Be sure to keep the DVD/VCR COMBINATION UNITS connection cables separate from the TV antenna cable
when you install the DVD/VCR COMBINATION UNITS, because it may cause electrical interference when
you are watching television programs.

DVD/VCR TO TV CONNECTION

1. Disconnect the AC power cord of the TV from the
AC outlet.
2. Disconnect the antenna or cable from the TV.
3. Connect the antenna or cable to the ANT-IN jack of
the DVD/VCR COMBINATION UNITS.
4. Connect the DVD/VCR COMBINATION UNITS to
the TV using the RF cable.
5. Plug the AC power cords of the DVD/VCR COM-
BINATION UNITS and TV into the AC outlets.
[VHF/UHF
[Indoor antenna]
combination antenna]
OR
[Cable box or satellite box]
OR
IN
OUT
From Cable or
Satellite Company
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected
to the grounding system of the building, as close to the point of cable entry as practical.
Antenna/Cable signal
A/V-compatible or
wide screen TV
Notes
¡
Connect the DVD/VCR COMBINATION UNITS directly to a TV. If the A/V cables are connected to a
VCR, pictures may be distorted due to the copy protection system.
HOOKUPS
[Back of the DVD/VCR]
[Back of the
UHF/VHF combination TV]
RF cable
DVD/VCR VCR (supplied)
AUDIO OUT
ANT-IN
UHF/VHF
L
R AUDIO IN
ANT-OUT VIDEO OUT
VIDEO IN

CONNECTING TO A TV

DVD/VCR VCR
AUDIO OUT
ANT-IN
L
R AUDIO IN
ANT-OUT VIDEO OUT
VIDEO IN
To ANT. IN
of TV
To VIDEO INPUT jack To VIDEO OUT jack
To Right (red) and Left (white)
To AUDIO INPUT jacks To AUDIO OUT jacks

RF OUTPUT CHANNEL

If your TV does not have A/V terminals:
1. Connect the DVD/VCR COMBINATION UNITS
to a TV using RF cable (see DVD/VCR TO TV
CONNECTION).
2. Select channel 3 on your TV.
3. Press PLAY.
¡
If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback.
¡ There is case that the RF output channel does not
change by situation (For example, when you adjust
tracking using CHANNEL(UP/DOWN)).
In this case, stop the playback, and start the play-
back again. After that, press PLAY on the VCR for
3 seconds.
¡
If there is a power failure or the DVD/VCR COM-
BINATION UNITS is unplugged for more than 30
seconds, the RF output channel setting will return to
CH3.
S-VIDEO
OUT
– 13 –
DVD
COMPONENT AUDIO DIGITAL
VIDEO OUT OUT AUDIO OUT
Y
Cb L
COAXIAL
Cr R
[Fig. 1]
EN
1L25