Hitachi CM776ET User Manual page 6

Table of Contents

Advertisement

ACAUT/OIVS
(Continued)
A
CAUTION
for 200-
240V operation
only
This equipment relies on the protective devices in the building installation for short-circuit
"=
and over-current protection. Refer to the following table for the suitable number and
location of the protective devices which should be provided in the building installation.
.-
Informative
examples of
protective
devices in single - phase equipment or sub - assemblies
Protection
Minimum number
Location
against
of fuses or circuit -
breaker poles
Case A:
Equipment
to be Earth faults
1
Phase conductor
connectedto POWER SYSTEMS Over current
1
Either of the two
with earthed
neutral reliably
conductors
identified, except for Case C
below.
Case
B:
Equipment
to be Earth faults
2
Both conductors
connected
to
any
supply,
Over current
1
Either of the two
including IT POWER SYSTEMS
conductors
and supplies with reversible
plugs, except for Case C below.
Case
C:
Equipment
to be Earth faults
2
Each phase conductor
connected
to 3-wire
power Over current
2
Each phase conductor
systems with earthed neutral
reliably identified.
Verify that the protective devices in the building installation meets the conditions in the
table prior to installing the equipment.
~
Be careful
of static electricity
on CRT surface!
To prevent electrical shock by the static electricity on the CRT surface, disconnect the
power cord at least 30 seconds after turning OFF the power.
~
Avoid frequent
power
ON-OFF
switching
!
Do not repeat OFF and ON power switching in a short period.
This may cause blurred
colours or distortion of the displayed pattern.
~
Be careful
of generated
magnetism
!
After the power has been turned ON or when the degauss function has been manually
engaged, the CRT is demagnetised for approximately 7 seconds.
This generates a
strong magnetic field around the front cover which may affect the data stored on
magnetic tape or disks near the front cover.
Place such magnetic recording equipment
and tapesldisks away from this unit.
~
About
cleaning
Before cleaning, turn OFF the power switch and disconnect the plug from the power outlet.
For the screen, use water with a lightly moistened soft cloth such as a gauze type material.
For the cover, use water or a liquid synthetic detergent, with a lightly moistened soft cloth.
Do not clean the inside of monitor by yourself as it is very dangerous.
Refer to your dealer.
Do not use aerosol sprays, solvents or abrasive cleaners.
?-4

Advertisement

Table of Contents
loading

Table of Contents