Setting The Daily On Timer; Disc Handling - Hitachi AX-M76 Instruction Manual

Setting the Daily on Timer

You can use the setting timer to make the unit automatically turn on at a certain time everyday from
standby. When the setting timer is on, the timer indicator " " will be displayed. But the clock must be
correctly set for the timer to operate correctly.
1. In standby mode, press the sleep/timer button (
displayed on the VFD and the hour indicator will blink.
2. Set the hour with the
3. Press the sleep/timer button (
4. Set the minute with the
5. Press the sleep/timer button (
set the daily timer to "ON" (daily timer set is in effect) or "OFF" (daily timer set is to cancel) by
pressing the
VOL-
Caution:
* You can set the daily timer only in standby mode.
* The operating time of every step shouldn't be longer than 10 seconds or it will return to the time
display.
* Please select the sound source before turning into standby mode. e.g. CD, Radio.
To confirm the daily time
When you press the sleep/timer button (
daily time is displayed. Wait for a few seconds until the display returns to the time display.
To cancel the daily timer setting
In standby mode, repeatedly press the sleep/timer button (
Press the button or
VOL-
again to finish.
Disconnecting the mains from the unit also cancels the daily timer.

Disc Handling

1. To keep the disc clean, please don't touch the disc's surface when you are holding it. You should
hold the edge. (See fig. 1)
2. If the disc is dirty, it will affect the sound quality. Please use a clean and soft cloth to wipe the
disc from inside to outside. Don't wipe the disc in a circular direction. (See fig. 2)
3. Don't stick paper on the disc.
4. Don't put the disc in a place with direct sunshine or hot sources.
5. Do not play any damaged discs in this player.
6. When you have finished playing a CD, remove it from the CD player and store in its protector
cover.
or button.
VOL- VOL+
SLEEP/TIMER
or button.
VOL- VOL+
SLEEP/TIMER
or button.
VOL+
SLEEP/TIMER
button to set the daily timer to "OFF". Press the Sleep/Timer button
VOL+
Fig.1
) on the remote control, SET TIMER is
SLEEP/TIMER
) on the remote control, minute indicator will blink.
) on the remote control, the selected time is set. Then
) on the remote control in standby mode, the
SLEEP/TIMER
Fig.2
- 15 -
) until the "ON" is flashing.