Section Ii. Getting Readyto Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety - Kenmore 19233 - Computerized Drop-In Bobbin Sewing Machine Owner's Manual

SECTION II. GETTING READYTO SEW
Connecting machine to power supply
Foot control plug
Machine plug
Power supply plug
Power switch
Power supply cord
Foot control
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch _.
2. Insert the foot control plug _, machine plug _ into the
machine.
3. Insert the power supply plug _ into the outlet.
4. Turn on the power switch _.
Before using your sewing machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
without thread for a few minutes. Wipe away any oil which
may appear.
For your safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polarized plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model YC-542 is used with
Sewing Machine Model 385.19233XXX.
(XXX - represents numbers 000 through 999.)
Controlling sewing speed
Sewing speed is varied by the foot control.
The further down you press on the foot control, the faster
the machine runs.
\
J
6