Automatic Channel Scan; Manual Channel Scan; Clear Service List (*); First Time Installation - Hitachi L42VT U Instructions For Use Manual

Automatic Channel Scan

Automatic channel scan is started by pressing
OK button while Automatic channel scan item
is highlighted.
The following message appears on the
screen:
Highlight Yes or No by using " " or " " buttons
and press OK button to con rm.
If Yes is selected, automatic search starts.
Selecting No cancels automatic search.
After search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen:
Press the OK button to search for analogue
channels. The following menu appears on the
screen for analogue channel search:
Select your Country , Language and Text
language by using " " or " " and " " or " "
buttons. Press OK or RED button to continue. To
cancel, press BLUE button. The following menu
will be displayed during the automatic tuning:
After APS is nalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers and
names assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them via
the program table.

Manual Channel Scan

In manual channel scan, the number of the
multiplex is entered manually and only that
multiplex is searched for the channels. For every
valid channel number, signal level and signal
quality are shown on the screen.
In both manual and auto search any existing
channel in the database is not re-stored to avoid
redundant duplicates of that channel.

Clear Service List (*)

(*) This setting is visible only when the Country
option is set to Denmark, Sweden, Norway or
Finland.
Use this setting to clear channels stored. Press
" " or " " button to select Clear Service List and
then press OK. The following OSD message will
be displayed on the screen:
Press OK to cancel. Select Yes by pressing "
" or " " button and press OK to delete all of
the channels.

First Time Installation

The user can use this item to load default
settings, which were loaded to the receiver at
the factory.
To install factory settings, highlight "First Time
Installation" menu item and press OK button,
then you will be asked whether or not to delete
English - 30 -