Lightolier CALCULITE COMPACT FLUORESCENT DOUBLE & CORNER WALL WASHER TRIMS Installation

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local
regulations. To assure full compliance with local codes and regulations, check with your local electrical
inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTALLATION OF CALCULITE COMPACT FLUORESCENT
1.

FRAME-IN

See Frame-In-Kit Instruction Sheet for
installation instructions.
2.

REMOVE PRE-INSTALLED SPRINGS

Use pliers to remove all 4 springs on FRAME
(Fig.1)

3. SNAP-IN-SOCKET HOUSING

Engage RETAINING SPRING into SLOT of
REFLECTOR NECK (Fig. 2). NOTE: Refer to label
on inside of REFLECTOR NECK for proper lamping
position. See Frame-In-Kit for lamp information.

4. INSTALL SOCKET HOUSING ASSEMBLY

Pass SOCKET HOUSING ASSEMBLY through
aperture opening of FRAME as shown in (Fig. 3).
5. SNAP-IN-SOCKET HOUSING ASSEMBLY TO
FRAME
a) Align side legs of SOCKET HOUSING ASSEM-
BLY with vertical MOUNTING SUPPORTS on
either side of FRAME.
b) Snap prongs on bottom of side legs into slot on
FRAME until SOCKET HOUSING ASSEMBLY is
secure to FRAME (Fig. 4).

6. INSTALL KICK REFLECTORS

We recommend using clean white or plastic film
gloves when installing reflectors to avoid finger-
prints.
a) Align SLOT in top portion of KICK REFLECTOR
with CLIP on RING (Fig. 5).
b) Repeat for second KICK REFLECTOR.
DOUBLE & CORNER WALL WASHER TRIMS.
RETAINING SPRING
REMOVED
JUNCTION BOX
FRAME
RING
INSTRUCTION SHEET NO.
IS:8021DW
A0399
SOCKET HOUSING
REFLECTOR NECK
MOUNTING FRAME
FIG. 1
SOCKET HOUSING
ASSEMBLY
FIG. 3
KICK
REFLECTOR
CLIP
SLOT
®
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
Page 1 of 2
RETAINING
SOCKET CUP SUPPORT
FIG. 2
SOCKET
HOUSING
ASSEMBLY
MOUNTING
FRAME
MOUNTING
SUPPORT
FIG. 4
FIG. 5
SPRING
SLOT
SUPPORT