Emerson EM-237C Owner's Manual

Owner's Manual Location of controls
[VOLUME UP]
[POWER]
ON/OFF
Answer/end a call
Charging the Bluetooth Headset
1. Connect the smaller end of the USB cable to the charging
port of the headset.
2. Connect the other end of the USB cable to either the:
� • AC Charger, and plug into a wall (A/C) outlet.
� • Computer's USB port.
• Car Charger
3. The RED LED indicator light turns on.
4. The RED LED indicator light shuts off when the headset is
fully charged (approximately 4 hours).
®
NOTE: When the battery is running low, the RED indicator light starts

Wireless Headset

to flash.
Model: EM-237C
In the box
Charging port
Headset
Car Charger
NOTE: Make sure you charge your headset for 4 hours before
using it for the first time.
Bluetooth Headset
Pairing the headset with a Bluetooth enabled phone
Owner's Manual
1. Make sure the Bluetooth Headset is turned off.
2. Keep your Bluetooth Headset and mobile phone within 3
® feet of each other during the pairing process.
Wireless Headset
Model: EM-237 3. Press and HOLD the [POWER] button until the RED and BLUE
lights flash alternately.
AC Charger USB Charging Owner's
Cable Manual
Drive Safe
within 3 feet
Driving while talking on your mobile phone is dangerous, and
illegal in many states.
Although this device enables drivers to conduct handsfree
conversations, it is still dangerous to drive and use a mobile phone
at the same time.
We recommend pulling over before making or answering calls, NOTE: To enter the Pairing Mode, you must press and HOLD the
especially during adverse driving conditions. Please use your power button for approximately 10 seconds.
mobile phone, and our product responsibly while driving!
4. Set your mobile phone to search for Bluetooth devices.
Bluetooth: Enabled
Paired Devices:
*Empty *
Indicator light
Searching for devices
[VOLUME DOWN]
1 found
Charging port Stop
5. When the phone finds the headset, confirm by selecting
Microphone
EM237C from the list.
Bluetooth: Enabled
Paired Devices:
EM237C
Select Device:
EM237C
Cancel
6. Enter passcode "0000" when prompted by the phone.
Bluetooth: Enabled
Paired Devices:
EM237C
Enter numeric passkey
for EM237C:
USB Cable
0000
OK
AC Charger
7. Your mobile phone will confirm that the pairing was completed,
and prompt you to accept the connection. Please respond
YES to connect the headset to your mobile phone. If the pairing
USB port
was successful, the headset' s indicator light flashes a steady blue.
Bluetooth: Enabled
PC
Paired Devices:
EM237C
Confirm connection to
Car Charger EM237C?
/
YES NO
8. When attempting to reconnect the headset to your mobile
phone, you may see the message below, and your mobile
phone will prompt you to accept the connection request to
the EM237C headset, and an option not to ask this again.
Please accept the connection, and if you select "Don't ask this
again" , your phone will automatically accept future connection
requests from your Bluetooth Headset.
Bluetooth: Enabled
Indicator light Paired Devices:
EM237C
Accept connection request
from EM237C?
/
YES NO
Don't ask this again
[POWER]
(Press & HOLD)
NOTE: The screenshots above are typical of many Bluetooth enabled
phones in the market today, and are used to assist in the
explanation of the pairing process. Your mobile phone's
interface and interaction with the Bluetooth Headset may
slightly differ from the illustrations above.
Using your Bluetooth Headset Wearing your Bluetooth Headset
Powering ON/OFF
• To turn ON, press and hold the [POWER] button until the
blue indicator light turns on.
• To turn OFF, press and hold the [POWER] button until the
RED LED indicator light flashes 3 times, and then shuts off.
Answering/Ending a call
• To answer a call, press and release the [POWER] button.
• To end a call, press and release the [POWER] button.
Adjusting the volume
Press the [VOLUME UP] or [VOLUME DOWN] button to adjust
the volume to the desired level.
NOTE: You may also adjust the volume from your mobile phone' s
For the best audio quality, always wear your Bluetooth
volume control.
Headset on the same side of the body as your mobile phone.
To make a call
Dial the number and press the send button on your mobile
Troubleshooting tips
phone, the call is automatically transferred to the headset.
I cannot get the Bluetooth Headset into Pairing Mode
•
Make sure the Bluetooth Headset is turned off before
beginning the pairing process.
•
Press and hold the [POWER] button until the RED and BLUE
lights flash alternately, this will signal that the headset is in
Pairing Mode, and ready to connect to your mobile phone.
My mobile phone is not able to pair with the Bluetooth Headset
Rejecting an incoming call
•
Make sure that you fully charged the headset before pairing.
To reject an incoming call, press and HOLD the [POWER]
•
Keep your Bluetooth Headset and mobile phone within 3
button until you hear the confirmation tone.
feet of each other during the pairing process.
•
Check that your phone's Bluetooth feature is turned ON.
•
Try repeating the pairing process, see "Pairing the headset
Redialing the last number called (Dependent with a Bluetooth enabled phone."
on your phone supporting this feature)
Press the [VOLUME DOWN] button for 3 seconds, and
release. The last number called will be redialed. After successfully pairing my mobile phone and Bluetooth
Headset, when I shut my phone and turn it on again, my
headset did not automatically connect
Voice dial (Dependent on your phone support-
•
Try turning the headset OFF, and then turning it ON again.
ing this feature)
During the Standby Mode, press and HOLD the [POWER]
•
Many mobile phones have an auto reconnect option when first
button until you hear the confirmation tone, and then say a
attempting to reconnect to a newly paired Bluetooth device.
name from your phone's contact list.
Make sure you accept this option, so that your Bluetooth Headset
automatically reconnects to your mobile phone; check the user
guide of your mobile phone for more information regarding
Transferring calls
this option.
To transfer calls between your Bluetooth Headset and
phone during a conversation, press and HOLD the
•
Try unpairing the headset from your phone, and repeat the pairing
[VOLUME UP] or [POWER] button (depending on the type
procedure
of mobile phone you have) until you hear the confirmation
tone. To transfer the call back to the Bluetooth Headset
press and HOLD the [VOLUME UP] or [POWER] button
I hear distortion, and the sound quality is poor
once again until you hear the confirmation tone.
•
For the best audio quality, always wear your Bluetooth Headset
on the same side of the body as your mobile phone.
Microphone mute
•
Check that the battery is charged enough.
Press and HOLD the [VOLUME DOWN] and [VOLUME UP]
buttons simultaneously until you hear the confirmation
The sound is very low
tone. The microphone of your Bluetooth Headset will be
mute. While it i s in Mute Mode, your Bluetooth Headset
•
Try adjusting the volume by using the [VOLUME UP] or
will beep every 5 seconds. To cancel mute mode, press and
[VOLUME DOWN] button on your headset; make sure the
HOLD the [VOLUME DOWN] and [VOLUME UP] buttons
volume on your mobile phone is turned up as well.
again until you hear the confirmation tone.
Safety information Warranty information
Limited Warranty
• Check local laws regarding use of a mobile handset and wireless
headset while driving. If you use the Bluetooth Headset while In the unlikely event that this product is defective, or does
not perform properly, you may within ninety (90) days from
driving, ensure your attention and focus remains on your driving.
your original date of purchase return it to the authorized
• Observe all signs in the designated areas where some electronic
service center for repair or exchange.
devices or RF radio products are required to be switched off.
These could include airplanes, hospitals, blasting areas, and
TO OBTAIN WARRANTY SERVICE:
potentially explosive atmospheres.
• Provide proof of the date of purchase within the package
(Dated bill of sale).
• Prepay all shipping costs to the authorized service center,
CAUTION: Although this device enables drivers to
and remember to insure your return.
conduct handsfree conversations, it is still dangerous
• Include a return shipping address (no P.O. Boxes),
to drive and use a mobile phone at the same time. a telephone contact number, and the defective unit within
the package.
Always keep your full attention on your driving.
• Describe the defect or reason you are returning the product.
Your product will be repaired or replaced, at our option, for the same
Product maintenance
or similar model of equal value if examination by the service center
determines this product is defective. Products received damaged
• Power off this product when not in use. as a result of shipping will require you to file a claim with the carrier.
• DO NOT expose this product to water or other liquids.
• DO NOT use abrasive cleaning solvents to clean the Bluetooth Headset.
The shipping address of the authorized service center is:
• If you will not use the Bluetooth Headset for long periods, be sure to
Southern Telecom Inc.
store it in a dry place, free from extreme temperature, humidity and dust.
ATTN: Returns Department
FCC and telephone company information
FCC Part 15
Should you have any questions or problems concerning this
This equipment has been tested and found to comply with the
product, please contact our customer service department at:
requirements for a Class B digital device under Part 15 of the
Federal Communications Commission (FCC) rules. These
1-877-768-8483 (Toll Free)
requirements are intended to provide reasonable protection
Monday - Thursday: 9AM - 5PM (EST)
against harmful interference in a residential installation. This
Friday: 9AM - 3PM (EST)
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular cs@southerntelecom.com
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
Warranty service not provided
the interference by one or more of the following measures: This warranty does not cover damage resulting from accident,
misuse, abuse, improper installation or operation, lack of reasonable
care, and unauthorized modification. This warranty is voided in
• Re-orient or relocate the receiving antenna.
the event any unauthorized person opens, alters or repairs this
• Increase the separation between the equipment and receiver.
product. All products being returned to the authorized service
• Connect the equipment into an outlet on a circuit different center for repair must be suitably packaged.
from that to which the receiver is connected.
Limitation of Warranty:
• Consult the dealer or an experienced radio/TV technician for help.
• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY
APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
Do not attempt to repair or modify this equipment.
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE
Warning: Changes or modifications to this equipment not
HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION
expressly approved by the party responsible for compliance
GIVEN BY SOUTHERN TELECOM INC. IT'S AGENTS, OR EMPLOYEES
could void the user's authority to operate the equipment.
SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE
SCOPE OF THIS WARRANTY.
Industry Canada
• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY
IS THE EXCLUSIVE REMEDY OF THE CONSUMER. SOUTHERN
Operation is subject to the following two conditions: (1) This
TELECOM INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR
device may not cause interference and (2) This device must
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
accept any interference, including interference that may PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS
OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER
cause undesired operation of the device.
OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED
BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE
The term "IC:" before the certification/registration number
EXTENT PROHIBITED BYAPPLICABLE LAW, ANY IMPLIED WARRANTY
only signifies that registration was performed based on a OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE
ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY
Declaration of Conformity indicating that Industry Canada
PERIOD SET FORTH ABOVE.
technical specifications were met. It does not imply that
Industry Canada approved the equipment.
Some states do not allow the exclusion nor limitation of incidental
or consequential damages, or limitations on how long an implied
warranty lasts so the above limitations or exclusions may not apply
to you. This warranty gives you specific legal rights, and you also may
have other rights that vary from state to state.
www.emersonphones.com
Manufactured by Southern Telecom Inc. Brooklyn, NY 11232
© 2009 Southern Telecom Inc. All rights reserved.
Emerson and the G-Clef logo are registered trademarks of
Emerson Radio Corp. Parsippany, New Jersey USA.
The Bluetooth® word mark and logos are owned by the Bluetooth
SIG, Inc.
14-C 53rd Street
Brooklyn, NY 11232
or
via e-mail at