In Equalizer menu, the preset can be changed to
Music, Movie, Speech, Flat, Classic and User.
Press the "MENU" button to return to the previous
Note: Equalizer menu settings can be changed
manually only when the Equalizer Mode is in User.
Balance: This setting is used for emphasizing left or
right speaker balance.
Headphone: Sets headphone volume.
Sound Mode: You can select Mono, Stereo, Dual I
or Dual II mode, only if the selected channel supports
AVL: Automatic Volume Limiting (AVL) function sets the
sound to obtain ﬁ xed output level between programmes
(For instance, volume level of advertisements tend to
be louder than programmes).
Digital Out: Sets digital out audio type.
Conﬁ guring Your TV's Settings
Detailed settings can be configured to suit your
Press "MENU" button and select Settings icon by
using " " or " " button. Press OK button to view
Operating Settings Menu Items
" or " " button to highlight a menu item.
OK button to select an item.
MENU" button to exit.
Settings Menu Items
Conditional Access: Controls conditional access
modules when available.
Language: Conﬁ gures language settings.
Parental: Conﬁ gures parental settings.
Timers: Sets timers for selected programmes.
Date/Time: Sets date and time.
Sources: Enables or disables selected source
Other Settings: Displays other setting options of
the TV set.
Using a Conditional Access
IMPORTANT: Insert or remove the CI module only
when the TV is SWITCHED OFF.
In order to watch certain digital channels, a
conditional access module (CAM) can be necessary.
This module must be inserted in the CI slot of your
Obtain the Conditional Access Module (CAM) and
the viewing card by subscribing to a pay channel
company, then insert those to the TV using the
Insert the CAM and then the viewing card to the
slot that is located in the terminal cover at the rear
side of the TV.
The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The CAM or
the TV terminal may be damaged if the CAM is
Connect the TV to the mains supply, switch on
and then wait for few moments until the card is
When no module is inserted, "
Interface module detected" message appears on
Refer to the module instruction manual for details
of the settings.
Viewing Conditional Access Menu (*)
(*) These menu settings may change depending on
the service provider.
Press "MENU" button and select the icon by using "
" or " " button. Press OK button to view Settings
menu. Use " " or " " button to highlight Conditional
Access and press OK to view menu items.
English - 25 -