Important Notes For Operation; General Information; Emergency Interrupt; The Symbols On Your Video Recorder Display - Hitachi VTMX905EUK Operating Instructions Manual

3.

IMPORTANT NOTES FOR OPERATION

General information

Note: You can switch on with
buttons or by putting in a cassette.
0-9
* If you have not used the video recorder for a few minutes,
it will switch to standby automatically. For more information,
please read the section 'Automatic switch-off' in chapter
'additional functions'.
* If you have switched the video recorder off with
, the time will show in the display, for instance ,
STANDBY m
'18:00'.
If the clock has not been set, '--:--' will appear.
* Keep your video recorder connected to the mains at all
times to ensure that programmed recordings can be made
and that the television works normally. Power consumption
less than 4W.
* If the video recorder is not plugged into the mains, it will
usually store TV channels for one year and timer and date
information for three hours.

Emergency interrupt

You can use on the video recorder or the remote
STANDBY m
control to interrupt any function.
So if you are having operating problems, you can just interrupt
the function and start again.
And you can practise operating your set without any worries.
No matter which buttons you press, you cannot damage it.
, the number
STANDBY m

The symbols on your video recorder display

These symbols can light up on your video recorder display:
This is where the current operating mode is shown
as a symbol.
LP When you have switched on the LP (Long Play)
function or when you play a tape that has been
recorded in LP (Long Play).
When you have switched on the child lock.
When you are making a recording.
k
When you have programmed a recording or when
a programmed recording is being made.
When you have put a cassette in the video
recorder.
DATE When the date of the programmed recording is
shown.
START When the start time of the programmed recording
is shown.
PROG. When the programme number of the programmed
recording is shown.
END When the end time of the programmed recording
is shown.
Display of programme number / tape position /
channel name / function.
Tape position in seconds.
9