Hitachi 37LD8D20U Instructions For Use Manual page 16

This menu includes the following items:
1. Add New Channels
2. First Time Installation.
ADD NEW CHANNELS:
This tuning menu consists of two parts:
Automatic Search
Manual Search
Installation
Add New Channels
First Time Installation
Automatic Search:
Automatic search is started by pressing the "OK"
button in the auto-search pop up menu. All the ser-
vices are searched and a channel table is created
automatically.
All channels found are stored in a sorted form with
respect to their channel numbers. Some services
may not appear with the correct channel number. At
the time of printing, not all broadcasters are sending
their channel number information.
Manual Search:
In manual search, the number of the multiplex is en-
tered manually and only that multiplex is searched for
the channels. For every valid channel number, signal
level, signal quality and network name are shown at
the bottom of the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
FIRST TIME INSTALLATION
The user can use this item to load default settings,
which had been loaded to the receiver at the factory.
To install factory settings, highlight "First Time In-
stallation" menu and press the "OK" button, then
you will be asked to confirm for deleting all channels
and settings.
Installation
Add New Channels
First Time Installation
Your previous digital channel list will be destroyed.
Are you sure you want to delete all digital channels
and settings for first time installation?
Yes
By selecting YES and pressing the "OK" button, the
existing channel table will be deleted.
After factory settings is loaded, "First Time Instal-
lation" menu will be displayed.
Automatic Search
Manual Search
No
English - 15 -
Please ensure aerial is plugged in. Do you
want to start first time installation?
Yes
Press the "OK" button to start installation. After search
is completed for digital channels, a message asking
search for analogue channels appears on the screen.
Do you want to search for
analogue channels?
Yes
Press the "OK" button to search for analogue
channels.The following menu appears on the screen
for analogue channel search.
Country
Language
TXT Language
PLEASE CHECK ANTENNA CABLE
AUTO PROGRAMMING SYSTEM
UK
First of all choose Language,Country and TXT Lan-
guage by using /
affect the sort process in APS. To start APS press
"OK" button:
APS is running...
UK
P 03 - C 04
After APS is finalized, the programme table will ap-
pear on the screen. In the programme table you will
No
No
Ok
Cancel
and / buttons. This will
63.75 MHz
6%
63.75 MHz
Cancel