Lightolier Calculite Evolution IC Airseal C3AICLV Specification

Page 1 of 1
10 1/8"
14 5/8"
(257mm)
(372mm)
11 3/16"
(284mm)
9" (229mm)
22 3/8"
(568mm)
Ceiling Cutout: 3-1/2" (89 mm) Dia.
For Complete Fixture Order: Trim Kit + Frame-In Kit. Each Sold Separately.
Frame-In-Kit
C3AICLV Magnetic 120V
C3AICLVE1 Electronic 120V
Note: Magnetic not recommended for residential or noise sensitive areas.
Features
1. Inner / Outer Housings: Inner Housing - Drawn, 0.036" (20 Ga.) steel. Matte
black finish. Tight rigidly built housing minimizes air leakage to less than
2 CFM at 1.57 PSF (or 75pa), which complies with Model Energy Code and
Washington State Energy Code and reduces heat loss and condensation in
ceiling. Outer Housing - Die-formed, 0.040" aluminum. Top cover removable
for access to transformer. U.L. listed for direct contact with thermal insulation.
2. Mounting Frame: Die-formed, 0.036" (20 Ga.) steel, matte black finish. 1/2"
deep integral lip. Four slots are positioned 90° apart to simplify alignment.
3. Trim Kit Horizontal Adjustment Mechanism: Die-formed steel ring, matte
black finish. Provides 362° horizontal stop, lockable with Philips screwdriver.
4. Thick Ceiling Vertical Adjustment Mechanism: Adjustable trim kit verti-
cally to accommodate up to 2" thick ceiling, tool less and lockable.
5. Mounting Bars: Galvanized steel, 0.059" (#16 ga.). Bars pivot for easy
attachment and wire-in below ceiling line. Pre-installed telescoping bars
extend to accommodate 16" to 24" O.C. joist spacing. Bars can accommodate
12" O.C. joist spacing after a slight field modification. Integral nails for
secure attachment to wood; attach to T-bar ceilings with out the need of
accessories.
6. Lamp holder: Procelain bi-pin socket. Pre-wired with No.18 AWG Teflon leads.
7. Junction Box: 3-1/2" X 4" X 2-3/8" deep; 0.063" (#14 ga.) galvanized steel.
UL listed for maximum of (8) No. 12 AWG 90° C through branch circuit con-
ductors. Accessible from inside and outside of luminaire. Outside J-Box door
is hinged for maximum opening.
8. Thermal Protector (not shown): Meets NEC and UL requirements.
9. Trim Kit: Order Separately. See individual trim kit specification sheets for
information.
Electrical:
Transformer: Replaceable from below; Transformer door rotates into fixture, posi-
tioning transformer directly over aperture to allow one-handed removal Magnetic:
120V 60 Hz., core & coil. Note: Magnetic not recommended for residential or
noise sensitive areas. Electronic: 120V 50/60 Hz., regulated lamp voltage, HPF,
EMI and circuit protections, thermal auto-reset, quiet operation.
Calculite Evolution IC Airseal
®
8
9" (229mm)
Plus Ceiling Thk.
9 1/2"
(242mm)
1/2" (13mm) Lip
Lamp
Downlight
Open
20W-50W MR16 (12V)
Reflector
20W-50W MR16 (12V)
C3MRD
Series
Frame-In Kit
®
7 2 4 1 9
3" (76mm) Dia.
4" (102mm) Dia.
Trim Kit (See individual Trim Kit Specification Sheets)
Wall Washer Adjustable Accent
1-1/4" Downlight Cone
Pinhole (Wet Loc.)
C3MRPD C3MRL C3MRA
Series Series Series
Dimming Controls: Use only dimmers specifically designed for use with
magnetic or electronic transformers. Consult Lightolier Control for information.
Low voltage luminaires may produce audible sound when used with dimmers,
which may be objectionable in acoustically critical areas.
Labels
U.L. (Suitable For Damp Locations), I.B.E.W.
Complies with Air Leakage Requirements as stated in the Model Energy Code
and the Washington State Energy Code.

Options and Accessories

Plaster Trim Ring (use with flangeless trim kit): CA3FMR
Job Information
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lightolier
a Genlyte company
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2011 Genlyte Group LLC • D0711
C3AICLV
3" Aperture, MR16 (12V)
6 3 1
Gasslite Gasslite
Cone 1-1/4" Downlight Adjustable
(Wet Loc.) (Damp Loc) (Wet Loc.) (Wet Loc.)
C3MRW C3MRPA C3MRGD C3MRGA
Series Series Series Series
Type:
www.lightolier.com
5
2" (59mm) Max.
Ceiling Thk.