Inserting Batteries In The Remote Control Handset; Operating Range For The Remote Control; Switching The Tv On/Off; To Switch The Tv On - Hitachi 32LD30U Instructions For Use Manual

Inserting Batteries in the
Remote Control Handset
• Remove the battery cover located on the back
of the handset by gently pulling backwards
from the indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions
and replace the battery cover.
Note : If you are not going to use the remote control
for a long period, please remove the batteries in
order to avoid any battery leakage. Otherwise, the
remote control can get damaged because of battery
leakage.
Operating Range for the
Remote Control
• Point the top of the remote control toward the
LCD TV's remote sensor LED while pressing
a button.
Remote range is approximately 7m/23ft.

Switching the TV On/Off

To Switch the TV On

· Connect the power cord to the 220-240V AC
50 Hz.
· Switch the "
TV will switch on. Then, press "
switch the TV into standby mode. Then the
standby LED lights up.
· To switch on the TV from standby mode
either:
· Press the "
button on the remote control.
· Press the -P/CH or P/CH+ button on the TV.

The TV will then switch on.

Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Switch the "
TV will switch
• To power down the TV completely, unplug
the power cord from the mains socket.
English - 17 -
" button to position "|" so the
" button, P+ / P- or a numeric
" button to position "
OFF.
" button to
" so the