Rear Panel - Hitachi DV-RV8500E Instruction Manual

Rear Panel

AERIAL
Connect the aerial to this terminal.
Mains Lead
Plug into the power source.
AERIAL OUT
Passes the signal from the AERIAL to your TV/monitor.
Important Note
About Ferrite Core
Be sure to attach the ferrite core to the mains lead (for
connecting to this unit).
This ferrite core can reduce noises.
1
Push the stopper [a] of the ferrite core to open.
2
Wind the mains lead twice on ferrite core.
3
Close the ferrite core until it clicks.
Caution
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
14
COMPONENT/PROGRESSIVE SCAN VIDEO OUT (Y Pb Pr)
Connect to a TV with Y Pb Pr inputs.
AUDIO OUT (Left/Right)
Connect to an amplifier, receiver or stereo system.
COAXIAL (Digital audio out jack)
Connect to digital (coaxial) audio equipment.
OPTICAL (Digital audio out jack)
Connect to digital (optical) audio equipment.
VIDEO OUTPUT Switch
Select either COMPONENT/PROGRESSIVE SCAN VIDEO OUT or RGB
signal of EURO AV1 AUDIO/ VIDEO terminal depending on how you connect
the Recorder to the TV.
S-VIDEO OUT
Connect to a S-Video Input on TV.
EURO AV 2 DECODER
Connect the audio/video output of an external source
(Pay-TV decoder, Set Top Box, VCR, etc.).
EURO AV 1 AUDIO/VIDEO
Connect to a TV with SCART jack.
1
2
ips
• Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the recorder. Use only one of the connections
described below.
• Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
[a]