Table of Contents
Advertisement
Video
The disc revolves, but no image or
bad quality images are displayed.
Sound
No sound.
No audio output.
Timer
Timer lamp flickers.
Recording
Timer recording does not work
properly.
Remote control
The remote control doesn't work.
Other
I forgot my password for parental
supervision.
Is it possible to change a subtitle
and an audio signal on a recorded
disc?
Other problems
90 - English
• Check whether there is damage to or any foreign
material on your disc.
• Some low quality discs may not play properly.
• If scenes change from dark to bright suddenly, the
screen may shake vertically temporarily, but this is
not a fault.
• Are you watching a programme in slow or skip
mode?
If you are playing a programme at a speed other
than normal speed, sound will not be heard.
• Check the connections and settings.
• Check whether the disc is damaged. Clean the disc,
if necessary.
• Check whether the disc is inserted correctly with
the label facing up.
Check whether you have selected the correct digital
output options in the Audio Output Options menu.
(See page 31)
• Check there is enough space in the disc for
recording.
• Check whether the current disc is recordable or not.
Make sure to check before the start time of
recording.
• Re-check the recording time and the end time
settings again.
• Recording will be cancelled, if the power is
disconnected due to a power failure or another
similar reason while recording.
• Point the remote control at the remote control
sensor on your DVD recorder. Allow for proper
distance. Remove obstacles between your DVD
recorder and the remote control.
• Check whether the batteries are empty.
• Check for the DVD/TV selection button.
Press the (
) and (
recorder simultaneously when the power is on. All
settings including the password will revert to the
factory settings. Do not use this unless absolutely
necessary. (Note that this function is possible only
when no disc is inserted.)
A recorded disc is played with only the subtitle and
the audio signal which were selected during
recording.
• Read the table of contents and then find and read
the section describing your problem, and follow the
instructions given.
• Turn your DVD recorder off and on.
• If the problem still persists, contact a nearby Hitachi
service centre.
) buttons on your DVD
Advertisement
Table of Contents
