Faq; Manufacturer's Note - Motorola LD-W-1 Manual

LD-G-1 / LD-W-1

FAQ

§
Parts are getting too hot and/or start to smoke.
!
Disconnect the system from the mains immediately!
Possible cause: one or more connections are soldered incorrectly.
à Check the connections.
Possible cause: The connection of the motor is connected to
locomotive ground.
à Disconnect the connection from locomotive ground.
§
The locomotive lighting does not correspond to its direction of travel.
Possible cause: The forward and backward light connections have
been exchanged.
à Check the connections.
Possible cause: The connections of the motor to the points X11 and
X12 have been exchanged.
à Exchange the connections.
§
A lamp flickers (this is not a defect).
Possible cause: The lamp is connected with one side to locomotive
ground.
à If you do not want the lamp to flicker, disconnect it from locomotive
ground, insulate it and connect it to the return conductor (point X3).
§
The locomotive does not run.
Possible cause: The locomotive address is not set correctly.
à Check the solder bridges (if necessary with a magnifiying glass).
If you cannot find the problem, please return the decoder for repair
(address on the cover page).

Manufacturer's note

According to DIN VDE 0869, the person who builds this kit or brings the
circuit into operation is the manufacturer of the product. If he sells the
product to another person he is responsible for passing on all the
English
Page 33