Table of Contents
Advertisement
Installation Method
Angle setup
This installation hardware allows the display to be directed downwards freely at any angle from the vertical to 25ˇ.
This adjustment must always be done by 2 people.
Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware to the left or right.
If the angle is increased while you are adjusting the angle using the screw at the center of the bottom, it is difficult to turn the
screw. When this happens, adjust it at the center of the upper.
Turn the screws very carefully to avoid damaging the wall.
When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any further, because if
you do, you will apply excessive force, deforming the screw.
(A) Criterion for the vertical
location
Gap
disappears
Wall side hardware
When it is in this state, do not
turn the adjustment screw any
further in the closing direction.
Closing
A
Resin plate
44
En
(B) Criterion when its angle is
Back of the
plasma display
Resin plate
When it is in this state, do not turn
the adjustment screw any further
in the opening direction.
Hexagon wrench
Opening
25
ˇ
End face of the plate
Matched in both
directions
Notch
B
Tilt Angle Criteria
Angle
5
10
15
20
Measuring the opening distance X
enables approximate angle values to
be determined.
X
X
133mm
188mm
241mm
291mm
Advertisement
Table of Contents
