Mitsubishi Electric FR-F700 Manual page 49

Name
Manual controller
DC tach. follower
Three speed selector
Motorized speed setter
Ratio setter
PG follower
Master controller
Soft starter
Deviation detector
Preamplifier
Pilot generator
Deviation sensor
Frequency setting potentiometer
Frequency meter
Calibration resistor
Inverter setup software
(FR Configrator)
* Rated power consumption. The power supply specifications of the FR series manual controllers and speed controllers are 200VAC 50Hz, 220V/
220VAC 60Hz, and 115VAC 60Hz.
Type Applications, Specifications, etc.
For independent operation. With frequency meter, frequency
FR-AX
setting potentiometer and start switch.
For synchronous operation (1.5VA) by external signal (0 to
FR-AL
5V, 0 to 10V DC)
For three speed switching, among high, middle and low
FR-AT
speed operation (1.5VA)
For remote operation. Allows operation to be controlled from
FR-FK
several places (5VA)
For ratio operation. Allows ratios to be set to five inverters.
FR-FH
(3VA)
*
For tracking operation by a pilot generator (PG) signal (3VA)
FR-FP
*
Master controller (5VA) for parallel operation of multiple
FR-FG
(maximum 35) inverters.
For soft start and stop. Enables acceleration/deceleration in
FR-FC
parallel operation (3VA)
For continuous speed control operation. Used in combination
FR-FD
with a deviation sensor or synchro (5VA)
FR-FA Used as an A/V converter or arithmetic amplifier (3VA)
QVAH-10 For tracking operation. 70V/35VAC 500Hz (at 2500r/min)
For continuous speed control operation (mechanical
YVGC-500W-NS
deviation detection). Output 90VAC/90°
WA2W 1kΩ For frequency setting. Wirewound 2W 1kΩ B characteristic
Dedicated frequency meter (graduated to 120Hz). Moving-
YM206NRI 1mA
coil type DC ammeter
For frequency meter calibration. Carbon film type B
RV24YN 10kΩ
characteristic
FR-SW1-SETUP-
Supports an inverter startup to maintenance.
WE
*
*
*
*
*
*
Applicable
Inverter
Shared among all
models
*
Shared among all
models
50